ORMEC | SMLC Revision 2 Hardware
SMLC V2 Hardware

SMLC Revision 2.0 Hardware

SMLC hardware Revision 2.0 introduced locking 1394 connectors for the ultimate in reliability. SMLC hardware Rev. 2 includes three 1394 connectors on the SMLC-160 to simplify the topology of a ServoWire drive network as the number of axes increases. Note that SMLC revision 2.0 hardware requires SMLC firmware v2.6 or later.  SMLC firmware v2.6 is available to all registered users in the SMLC software section of the Support Library. In addition to the frequently asked questions (FAQs), consult this guide to replacing SMLC hardware.

SMLC v2 hardware, front view, with locking cable callout

Comparison of SMLC rev1.x and rev2.0 hardware

The figure below shows the differences between rev1.x and rev2.0 SMLC hardware

Hardware comparison

SMLC hardware revision is indicated by the product label on the left side of the unit. The revision field in the picture below indicates 2.0.00. In SMLC hardware rev2, the serial number suffix is greater than 200. In SMLC hardware rev1, the serial number suffix is between 100 and 200.

SMLC product label

SMLC Product Label

If you have questions about this revision that are not answered by the FAQ on the right, please contact ORMEC support at (585) 385-3520 or via e-mail at support@ormec.com

  
SMLC2 Hardware

Will SMLC firmware v2.6 or later work on my rev1.x SMLC hardware?

Yes. SMLC firmware v2.6 is backward compatible with all SMLC hardware revisions.

Sitemap
eNews Signup
Trademarks
Privacy StatementTerms Of UseCopyright © 2008-2015 ORMEC Systems Corp.